This site will look much better in a browser that supports current web standards, but it is accessible to any browser or Internet device.

Using 3D Chocolate Molds
For Solid Plaster Casting - Page 2

By Bob Sherman

This is page 2 of a two page article. If you arrived here from an outside link click here to view it from the beginning.

PLEASE NOTE!! - Plaster crafting is fairly safe if you observe these safety rules when mixing plaster. Once hardened there is little or no hazard from handling plaster items:

Plaster is very alkaline and and exposure to high dust levels may irritate the skin, eyes, nose, throat, or upper respiratory tract. Wear a dust mask, eye protection, and rubber gloves when mixing plaster.
Do not wear contact lenses when working with plaster.
Plaster generates a lot of heat when setting - never use plaster to make casts of body parts.
Keep away from children or pets.
Other safety precautions may apply depending on the plaster product you use - read the directions.

Step By Step Instructions - Continued From Page 1


9. The following step requires a knife. A standard utility knife is my preference. Use caution when handling a sharp knife.	10. The mold parting line (seam) needs to be trimmed. I cut away high areas and use a scraping motion on low areas.

11. An abrasive sponge works well for smoothing out the seam. When it clogs with plaster just rinse it out and it can be reused once it dries. Sandpaper may also be used but clogs rapidly and is not reusable.	12. Smooth the seam with the sponge. Tip: If you need to get into a tight area, cut a piece off the sponge with a scissors.

13. The finished plaster casting. At this stage it is still damp and I will let it air dry before painting.

Return To Page 1

Disclaimer: The information presented here is accurate to the best of my knowledge and common plaster crafting practices as of the time of this writing - March 2007. The author and the publisher accept no liability for the use or misuse of any of the information presented in this article. This article is presented for informational purposes and is used at your own risk.

Author: Bob Sherman

Publisher: Bobby's Craft Boutique Inc.

This article is provided free of charge for use in casting.

Web sites may use links to this page without restriction.

No portion of this article may be reproduced for publication elsewhere without express permission from Bobby's Craft Boutique Inc. with the following exceptions:

Non profit organizations such as religious groups, scouts, 4h, etc... may use this information without permission for printed materials provided it is used without modification and credit is given to both the author and onestopcandle.com
Reprinting to the web is prohibited without permission, however web sites wishing to link to this article may do so without permission.

All other requests need to be submitted via our reprint request form.

Home > Plaster Crafting Supplies > Plaster Craft Instructions > Using 3D Chocolate Molds For Plaster Page 2

Click here for current shipout time on orders

This site will look much better in a browser that supports current web standards, but it is accessible to any browser or Internet device.

Using 3D Chocolate Molds For Solid Plaster Casting - Page 2

Step By Step Instructions - Continued From Page 1

Return To Page 1

Using 3D Chocolate Molds
For Solid Plaster Casting - Page 2